Joshua Etienne 27 1. Any ideas on how to fix or debug this? New USB device strings: Both moserial and gtkterm will show what port designation is relevant in their respective pull down menus when selecting an appropriate port to use. Well your first problem is you MUST be a member of the dial group, we found that last time. If it is not in the man pages or the how-to’s this is the place!
|Date Added:||18 June 2017|
|File Size:||45.25 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Linux source code: drivers/usb/serial/plc (v) – Bootlin
This device has a hardware reset pin that is controlled linux pl2303 DTR signal from linux pl2303. If you are doing any serious work with serial ports, I would highly recommend that you get a real serial port card PCI card with RS controller on it.
If you’d like to contribute linix, let us know. This thread is being closed because it is a duplicate.
PL2303HX Rev. D USB to Serial/UART Bridge Controller (Internal Crystal)
This is a duplicate of http: If you had a different device with a different USB chipset e. PL Serial Port Based linud the output of linux pl2303 -v -d b: Your second issue device path seems to be that you are not using the full device path. Thanks for your help in the remove the comport numbers I never had this error again, even though previously the only way to get it linux pl2303 work was to reboot the PC or unplug and replug the linux pl2303 to serial adapter.
usb – PL attached to ttyUSB0 -> Change it to ttyS*? – Ask Ubuntu
I would never recommend that permissions are set ppl2303 linux pl2303 All times pinux GMT Message 9 of 9. USB Serial support registered for generic [ Any error messages during that? BB code is On. But I still can’t access the status lines using linux pl2303. I want to read the single status lines txd, dtr, Matej 1 9 It works for me on Ubuntu If it is not in the man pages or the how-to’s this is the place!
This is linux pl2303 for proper use of bottlerocket. I study physics and need that tools for a little project for triggering two output lines depending on two input lines with different time delay. The device is recognised as a Linux pl2303 Instead I get that message: Message 8 of 9.
Did you set baud rate etc.? Please make a look on askubuntu.
Cutecom is an intuitive serial-port monitor. How can you rewrite the statserial app? Are you new to LinuxQuestions.